Enhancing NAS experience - The Community Package Hub is all about quality software, made for your Synology NAS. Collected from all over the world, reviewed and compliant to official requirements. Delivering thousands of packages to users every month ... become one of them today.

Reply to Thread

 Comments (1)
Page  1 
  1. TosoBoso wrote on Jan 02, 2019 at 08:55 AM

    All, to the points: #1 Open Relay, #2 NW bridge, #3 MariaDB5
    #1 K4S as open rely is a wrong assumtion and urban legend as you can easily verify with mxtoolbox.com etc.
    Check /etc/kopano/postfix/main.cf and find the following entries:
    # closed relay: allow localhost for clients sending; add your local nw if needed, extra entries are to deal with IPv6
    mynetworks = 127.0.0.0/8 [::ffff:127.0.0.0]/104 [::1]/128 192.168.0.0/16
    #2 K4S runs in docker bridge mode which is default and still reports as respective server in postfix mode (main.cf->myhostname).
    In postfix there are settings to hide the IP address and only show the hostname so the private bridge IP will not show.
    Note yy hidden feature it is also posible to run K4S in host aka non-bridge mode (/var/packages/Kopano4s/etc/package.cfg->DOCKER_NW="host") but this is experimental and after changin the setting you have to reset and rebuild the container > kopano4s-init reset.
    #3 K4S only needs MariaDB10 but v.0.9.3 is now fixed with bogus dependency to MariaDB5. Essentially this was a legacy from forking of Z4H.
    -TosoBoso

    Reply

Page  1 





Allowed tags: <b><i><br>Add a new comment: